JIAXING JICHENG MACHINERY CO.,LTD.
JIAXING JICHENG MACHINERY CO.,LTD.
Add to Cart
800 m/min PRO-14DT Copper Wire Drawing Machine with Inline Continuous Annealer
Product main usage and applying scope:
Product working environment and condition
1. Working environment
Height above sea level less than 1000m.
Environment temperature －10℃－40℃
Comparative environment temperature less than 85% (25℃)
2. Working condition:
(1) Working voltage: 380V 50Hz
(2) Maximum gas consumption: 0.3 cubic meter/minute
Main technique parameter:
1. Line in diameter: φ1.6mm
2. Line out diameter:φ0.68mm
3. Maximum anneal speed: 1200m/min
4. Anneal wheel diameter: φ200mm
5. Anneal type: DC three step anneal
6. Max. dies number: 14 (Customer self provided)
7. Dies outer diameter: ф25mm ×thickness8mm or 12mm
8. Mechanism surface reduce rate:
From No.1 to No.13 15%
No.14 8%
9. Drive motor: 18.5KW-4P AC motor and 18.5KW transducer
10. Reeling motor: 5.5KW-4P AC motor and 5.5KW transducer
11. Max. anneal current: 600A
12. Max. anneal voltage: DC50V
13. Cooling water tank capacity: 225L
14. Consumption amount of compressed air: 225L
15. Pressure of the compressed air: 0.4 Mpa
16. Steam consumption (taking care by customer): 2kg/h
17. Steam pressure: 0.2-0.3Mpa
18. Machine dimension(mm): 2798L×1600W×1780H
19. Machine total weight (kg): 3000
20. Capacity :260KGS/hour
Structure and principle of the machine
The machine is a three-step anneal device, the three contact wheels constitutes the pre-heat section, the anneal section and the dry-up section. The strap wheel which on the speed control wheel rear shaft drive the three contact wheel on the anneal device through the strap to keep the contact wheel has certain percentage synchronization in relation with the line drawing machine. Connect the positive pole and cathode to upper and lower anneal wheel, use the heat generated by current flow inside the copper line when contact with the contact wheel to achieve the purpose of preheat, anneal and dry-up.
